And here it is, a solemn moment. The theoretical drawing has been exported to Acad, where it will be “sliced” into parts. What bad? The process is quite time-consuming. What good? The accuracy of the parts obtained is plus or minus 0.05 mm ….
![](http://www.bnk.sobdelo.ru/wp-content/uploads/2021/11/french-longboat-xviii-16-1.jpg)
Now I can make frames and I can determine their shape and size.
![](http://www.bnk.sobdelo.ru/wp-content/uploads/2021/11/french-longboat-xviii-17.jpg)
In the Acad 2000, the frame acquisition process is a manual operation for each frame. With the Trim command, I cut off the lines of the theoretical drawing at the location of the future frame and connect the ends of the cuted lines with each other to get the frame.
![](http://www.bnk.sobdelo.ru/wp-content/uploads/2021/11/french-longboat-xviii-18.jpg)
To be continue…